Worn slip rings compromise the transfer of current from the rotating component of the generator to the brushes. With time, these can result in poor power transmission and the worst cases arcing and potentially a ring fire resulting in a forced outage.
Goltens Rotterdam’s in-place machining experts got the call to machine two sets of slip rings on a 43-year-old BBC generator with heavily worn slip rings. Evaluation with a straight edge showed a highly uneven wear pattern across the surface of the slip rings that required rectification.
Repairing the house slip ring
Goltens deployed its single-point journal cutting tools to the site and began the process of returning the running surfaces to an even condition.
The two sets of slip rings had been subject to previous machining repairs and were of differing outside diameters before the repairs. Also, the extent of the wear on the slip rings was uneven and each set required a differing amount of material to be machined away to get to a clean, full contact surface.
- Slip Ring #1 – Original diameter of 507mm with a post-machining diameter of 503.10mm (3.9mm)
- Slip Ring #2 – Original diameter of 509mm and a post-machining diameter of 508.2mm (0.08mm)
return to service
The entire repair was completed inside of 5 days onsite inclusive of waiting and staging. Both sets of slip rings were machined to a surface finish of 1.0Ra by the manufacturer’s specifications and the turbine generator was returned to service.