Boiler is of the two-pass, scotch type, built and stamped in accordance with the requirements of the ASME Code, and listed by the National Board of Boilers and Pressure Vessel Inspectors Engineered to fit easily in a 40 ft shipping container Large combustion chamber with low heat release for complete combustion Smoke box is front-mounted with slip-on stack connector Access to fireside is accomplished with davited rear door and with split front doors. Flame observation ports are on front and rear Openings for cleanout inspection of waterside are provided with 3" x 4" hand holes, and with 12" x 16" manholes (80 HP up) Insulated with 2" high-density mineral wool, lagged with 22 gauge grip jacketing, baked on epoxy enamel to resist chipping and fading Firetubes are rolled and beaded on power boilers, expanded and flared on low pressure boilers (2" dia. through 30 HP, 2 1/2" dia. 40 HP and up) Supports include lifting lugs securely welded to the top of shell; structural steel support legs on skids support the boiler so that special foundations are not required Operating & limit temperature control Modulating temperature control (when applicable) Probe type low water cut-off control Combination pressure, temperature and altitude gauge Hot water return baffle for shock resistance Safety relief valve(s) per ASME Code
| Make | Hurst Boiler |
|---|---|
| Manufacturer | Hurst Boiler & Welding |
| Model code | S250-4W-0030-0160 |
| Series | Series 250 |
| Type | Fire tube |
| Design pressure | 11.03 bar |
| Steam capacity | 1035 tons/hr |
| Fuel used | HFO (heavy fuel oil) |
| Power source | fuel oil |
| Width | 55 inch |
| Weight | 2064 Kg |
| Additional info |
|